Products

Twenty-position adjustment dial sticker for the Mahlkonig EK43 series grinders.

EK43 Dial Adjustment Cap complete

Complete Spout and Bag Holder Assembly.

Ball bearing seat for the Mahlkonig EK43 series grinders. This bearing seat is part of the face plate assembly. NOTE: The old part number is 300949.

Ball bearing washer/spacer for the Mahlkonig EK43 series grinders. Also compatible with the Guatemala and Kenia series grinders.

EK43 Base Plate - Black Color

EK43 Base Plate - Copper Color

EK43 Base Plate - White Color

Bearing plate in for the Mahlkonig EK43 series grinders.   NOTE: Currently only available in copper and stainless steel colors. 

Black grind adjustment scale sticker for the Mahlkonig EK43 series. Number scale runs from 0 to 16. ***REPLACING 700101 & 100101***

EK43 Burr Alignment Tool

This mechanical points type switch is what turns on the start capacitor, which gives the electrical boost to the motor when you first start the gri...

Circuit breaker, 12.0 Amps, 115V/250v 1~ also for EK43S, all Gua & Kenia, VTA SW single phase) ***REPLACING 302311***

Compression spacer (30 x 41 x 0,5) for the Mahlkonig EK43 series grinders.

This lives on the inside of your spout and is attached to the right rear spout screw. Upon installation, make sure that the strip is contacting the...

Cover, polished for bearing shield for older Mahlkonig EK43 series grinders.

Fits all three positions. ***REPLACING 301016***

Rotary shaft distance bushing for the Mahlkonig EK43 series grinders. St. 1.4305, 30/18H7 x 18mm.

EK43 Felt ring for grinder housing

Grind adjustment face plate for the Mahlkonig EK43 series grinders in black color. (old part number 306156). note : paint may differ slightly from ...

Grind adjustment face plate for the Mahlkonig EK43 series grinders in copper color. (old part number 306156). note : paint may differ slightly from...

Grind adjustment face plate for the Mahlkonig EK43 series grinders in white color. (old part number 306156). note : paint may differ slightly from ...

Grind adjustment spindle with fine thread pitch for the Mahlkonig EK43 series grinders. This is part of the face plate assembly. ***REPLACING 30095...

This adapter is needed to allow the top of the grind casing to accept the Mahlkonig Hoppers.