NutriMill Harvest Setup and Cleaning: First-Use Guide

Short answer

Place the Harvest on a hard stable surface, attach the hopper correctly, position a collection bowl and follow NutriMill's current first-use instructions. Start the mill before slowly adding grain. Keep routine cleaning dry and do not get the milling stones wet.

First-use checklist

1. Inspect the mill and packaging promptly.
2. Confirm the hopper, lid and cleaning brush.
3. Use a hard flat surface with room for the flour bowl.
4. Attach and lock the hopper according to the manual.
5. Set texture before adding grain.
6. Turn the mill on before slowly feeding grain.
7. Follow NutriMill's current rice-cleaning procedure before food use.
8. Let the hopper empty before switching off.

Cleaning routine

• Keep routine cleaning dry.
• Use the supplied brush around the spout and accessible area.
• Follow the current dry white-rice procedure when documented.
• Do not get the stones wet or remove the lower stone for routine care.

Common planning mistakes

• Adding grain before the motor runs.
• Forcing the finest setting.
• Milling an ingredient absent from current supported guidance.
• Using water on the stones.
• Planning a large session without reading operating/rest guidance.

FAQ

Should the mill run before grain is added?

Yes; follow the current manufacturer sequence and add grain gradually.

Can I wash the stones?

Do not get the stones wet. Use the documented dry-cleaning procedure.

Can I remove the lower stone?

Not for ordinary maintenance; use manufacturer support for service needs.

Why is flour too coarse?

Adjust gradually toward a finer setting while following the manual; do not force the stones together.